10" x 22" Bench metal lathe-C25

Features:

Right and left spindle rotation

Smooth speed adjustment in 2 ranges

Possibility of cutting left-hand threads

Possibility of cutting inch and metric threads

Cast iron bed is hardened and ground

Quick tailstock locking

Tailstock adjustment for cone turning

Automatic feed during turning

Three automatic turning or thread cutting modes on one guitar setting

High-power motor

The maximum processing diameter on the machine is 250 mm, the maximum distance between centers is 500 mm, and the processing diameter above the support is 140 mm, and for this, the machine is connected to a household network of 220 V, which means the machine can be used at home, in the garage, in the workshop and you will not need a 3-phase network. A powerful 1.1 kW engine will provide excellent processing on the machine and will rotate the spindle with Morse cones MK-4 in two ranges, with smooth adjustment, from 50 to 1250 rpm and from 100 to 2500 rpm. Let's figure out what features the C25 machine has. The machine is capable of cutting both right and left threads. It cuts metric and inch threads. Replaceable metal gears are used to cut threads, they are included with the machine. The machine is equipped with a feed box - this is another important feature of the machine. After you have collected the guitar you need from gears on the thread or automatic feed, you will have three speeds or three possible threads. For example, by collecting an automatic feed of 0.1 mm per spindle revolution from one set of gears, you get three automatic feeds: 0.1 mm / revolution, 0.2 and 0.4 mm per spindle revolution. Thus, on the machine, having two sets of gears, we get six automatic feeds, and there is no need to sort them out each time, we just turn the handle on the machine panel.

With all this, we still have the ability to change the direction of rotation of the spindle, both clockwise and counterclockwise. The ability to turn small cones, due to the rotation of the small longitudinal feed carriage. The ability to adjust the tailstock by 10 mm in both directions. The ability to adjust the wedge bars on the transverse and small longitudinal feed, and much more.

The C25 is supplied with everything you need to set up, maintain and work on the machine. The machine needs to be cleaned of preservative grease, lubricated at all points using the oiler, it is included in the kit, tighten the adjustment strips if necessary. All that remains is to buy additional cutters and you can start working.

The machine guides are hardened and ground, the average indicator for the bed is 60 HRC units.

Adjustment of guide clearances using wedge strips